![]() Then the hot wire coming off the blade going to the volume pot move that to the + on the jack? Sorry if my lingo/terms are a bit off I am just really trying to figure out how to brighten this guitar plus I dont care about a neck pickup especially as the stock neck pickup in this guitar sounds pretty bad and I never use a tone pot. ![]() Would I just have my bridge ground and pickup ground meet on the blade selector then go to the ground on my jack. I am tuned to drop A is it possible its just the short scale length with drop A making it sound all muddy? Regardless, I do not use tone pot and always wanted to wire up my pickup selector to be a killswitch. I installed a Duncan Invader in the bridge pickup and it just doesnt sound that great. A common complaint with the inexpensive volume potentiometer included in the. In other words, a volume control might have one channel measure 97K, and the other channel measure 107 K (typical. I have a conklin gtg-7 its a 25.5 inch scale length 7 string (26" from nut to holes not sure if that would be the scale length or not) but my issue with it is it just sounds all muddy and too warm. The bypass capacitor should be of a capacitance of approximately 1 of the. Volume control pots ('audio taper') are designed to work correctly in the conventional configuration, and every single pot I measured had closer tracking tolerance than it did matching of resistance between the channels. ![]() The pot is on the input whereas the thump is coming from the amp and C1 on the output. ![]() Looking at the schematic of Figure 4 we can see that this is unlikely to help. I am wanting to bypass my volume and tone pot and make my pickup selector blade a killswitch when in the neck pickup position. Since when you turn on the switch/pot, the pot is at its lowest level meaning volume is at the lowest level. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |